LEXIA 3 INTERFACE SERIAL

The solution is: Just buy a standard 10K Ohms 1/4 watt resistor and solder it between the two terminals, similar to the form shown in the snapshot*. But take care.ДЇor those haveВ tried to update the firmware from B to C with the file iвЂ™ve been downloading from WP74, but it makes no difference in working, and you canвЂ™t access the C CAN bus: Lexia-3 lexia3 V48 Citroen/Peugeot Diagnostic PP2000 V25 with Diagbox V7.8.3 Software PP2000/LEXIA-3 Interface works for both Citroen and Peugeot Diagbox V7.8.3 Software free provide This set contain less cables, without not necessary cables, is simple version of LEXIA-3.

LEXIA 3 INTERFACE SERIAL

If you wanna play you can edit the serial in the vci_. I took my clone for a long now so I do not remember when I did this tests but if I remmebr well was in May 2013 Then I tested it again in same cars after I flashed with Mr. NLC vci_ and in some cars that I know 100% that a вЂњBвЂќ clone didnвЂ™t worked before this вЂњCвЂќ clone didnвЂ™t worked too. I use my tool from time to time but what I wanna tell you is that when I bought my clone from china ( full chip with S/N 963830 C ) I tested as it is before reflash it with Mr. Open the вЂњvci_вЂќ with a HEX Editor and read what Mr. I bought my Lexia interface clone from china ( full chip with S/N 963830 C ) I tested as it is before reflash it with Mr.

Lexia 3 interface